Hama WAB137 - Manual (Page 4)

6 7
Contents:
1. Note on Instructions
2. Intended Use and Specifi cations
3. Parts List
4. Warning and Safety Instructions
5. Installation
6. Operation & Maintenance
7. Contact
------------------------------------------------------------------------------------------
1. Note on Instructions
Keep the instructions for the complete service life of the product and pass
them on to subsequent users or owners.
------------------------------------------------------------------------------------------
2. Intended Use and Specifi cations
The bracket is used for wall mounting fl at panel displays for private
household use.
Maximum load bearing capacity: 25 kg
Screen size: 25,0 – 94,0 cm (US: 10" – 37")
Depth: max. 16,5 cm
Angle: up to 15° (depends on the device)
Pivoting range: up to 160° on 2 joints and 1 carrier arm (depends on the device)
Wall mounting plate dimensions: 6,0 x 18,0 cm
Mounting holes: according to the VESA standard until 400x200
------------------------------------------------------------------------------------------
3. Parts List
See page 3.
Operating Instructions
4. Warning and Safety Instructions
For proper mounting, please have this bracket fi tted by a qualifi ed technician.
Please check that the assembly set for completeness before installing the bra-
cket and ensure that none of the parts are faulty or damaged. Use the bracket
for the intended purpose only. Before installing the bracket, ensure that the wall
on which the television is to be mounted is suitable for the weight and make
sure that no electrical wires, water, gas or other lines are located around the
installation location. Please note in particular that the provided wall anchors are
suitable only for concrete and brick walls. If the wall on which the television is to
be mounted is made of other materials, you should buy appropriate installation
material from a specialised dealer. Also observe the necessary safety clearance
around the TV set (depends on the model).
The bracket may not be mounted above locations where persons might linger.
Once you have mounted the bracket and the fl at panel display, check that they
are suffi ciently secure and safe to use. You should repeat this check at regular
intervals (at least every three months). If the bracket is damaged, remove the TV
and do not continue to use the bracket. Mount the TV and the bracket only with
the help of a second person. Adjust the bracket only with the help of a second
person. Ensure that electrical cables are not crushed or damaged during instal-
lation and adjustment. Do not place loads on the bracket that are heavier than
the load bearing capacity specifi ed and do not exceed the specifi ed maximum
size. Ensure that the bracket is loaded symmetrically. During adjustment, ensure
that the bracket is loaded symmetrically and that the maximum weight is not
exceeded.
Hama GmbH & Co. KG does not accept warranty claims for improperly installed
brackets or any resulting damage.
00132001bda.indd Abs1:6-Abs1:7 00132001bda.indd Abs1:6-Abs1:7 08.12.2009 13:49:09 Uhr 08.12.2009 13:49:09 Uhr