Hama VMPL3 - Manual (Page 7)

ENGLISH
Step 3: Attach Tilting Monitor Brackets to a television with a curved back or an obstruction near the threaded insert.
Note: After Completing Step 3, proceed directly to Step 6.
Determine the diameter of the Bolt (S,T,U,V) your television requires by hand threading them into the threaded insert on the back of the
television. If you encounter any resistance, stop immediately.
Once you have determined the correct diameter Bolt (S,T,U,V), see the appropriate diagram below, thread the Bolt through the appropriate
Lock Washer (W,X,Y,Z), corresponding Washer (CC,DD), Tilting Monitor Bracket (D,E) or Monitor Bracket Extension (B), a second
Washer (CC, M4/M5 diameters only), a Spacer (AA,BB) and finally into the television.
Make sure the Tilting Monitor Brackets (D,E) are vertically centered and level with each other.
Tighten the bolts (S,T,U,V) securing the Tilting Monitor Brackets (D,E) to the television.
Diagram 3
M4
Diameter Bolt
S
M6
Diameter Bolt
M8
Diameter Bolt
M5
Diameter Bolt
W
CC
CC
AA
D
T
X
CC
CC
AA
V
Z
DD
BB
U
Y
DD
BB
E