M-AUDIO Session with Fast Track USB - Manual (Page 7)

Session with Fast Track USB User Guide 6
|
3. The driver installer will launch.
Follow the on-screen direction
prompts. During Installation,
Mac OS X will ask you to enter
your user name and password.
Enter this information and click
OK to confirm. If you have not
configured a password for your
computer, leave the password
field blank and click OK. If
you are not the computer’s owner, ask the owner or your Administrator for the
missing information.
4. Click “Restart” once the installer has completed the installation.
5. Connect your Fast Track USB to your computer using the USB cable provided.
6. Your Fast Track USB audio interface is ready to use.
Connecting the Fast Track USB Audio Interface
Fast Track USB is compatible with Windows and Macintosh class-compliant USB
drivers, and will function as soon as it is connected to your computer. However, for
the best low-latency performance in Windows, you will need to install the M-Audio
drivers.
Once you have completed installing the Session software in Windows, connect the
M-Audio Fast Track USB to an available USB port on your computer. Your computer
will recognize the new hardware and Windows computers will briefly display a Found
New Hardware message. You may be prompted with a message that the driver being
installed has not passed Windows Logo Testing, or asked whether the program you
wish to run is a trusted application. Click Continue Anyway or Install to proceed with
the installation.
You may also see a Windows prompt asking if you would like to search the Internet
for a driver. If so, click No and continue.
Mac users can simply connect the Fast Track USB interface and start using the
device.
NOTE: In order to hear the audio signal produced by Fast Track USB, you must
either:
1. Connect the two RCA outputs (located on the Fast Track USB rear panel) to
powered monitors, an amplifier, or a mixer.
Or
2. Connect headphones to the headphone output, located on the front panel.