Storing your iron – ROWENTA TRAVEL IRON DA1510 User Manual
Page 6
Storing your iron
Note !
Make sure the iron is cold before storing it.
Do not use any cleaning or descaling products.
IMPORTANT Do not wind the cord around the hot soleplate.
Never store your iron placed down on the soleplate.
ON
OFF
120V 240V
00
MADE IN GERMANY
MADE IN GERMANY
ON
OFF
110V 240V
000
ON
OFF
NO
10 min
ON
OF
F
110
V
22
0V
Problems
and possible causes
Solutions
Your iron produces little or no steam
• The temperature selected is too low.
• The steam control is set on OFF.
• There is no water in the tank
.
Set the temperature control on •••
Switch the steam control to ON.
Fill the water tank.
Water is dripping from the holes in the soleplate
• You have been using the burst of
steam button too often.
• Steam is used before the iron is
hot enough.
• The iron is stored with water in the
tank.
Wait a few seconds between each shot.
Set the thermostat within the
coloured steam zone and wait until
the iron is hot (approx. 2 min.)
Empty the tank before storing the
iron and set the steam control to OFF.
• The problem persists.
Take your iron to an Approved
Service Centre.
HELPLINE:
if you have any product problems or queries, please contact our Customer Relations
Team first for expert help and advice:
0845 602 1454 - UK
(01) 677 4003 - Ireland
or consult our website - www.rowenta.co.uk
1103903520 - DA1510:Mise en page 1 21/05/08 14:17 Page 6