Maintenance and cleaning, 6 • cleaning the epilator head, 7 • cleaning the sensitive area accessory – ROWENTA ACCESSIM EP5510 User Manual

Page 8: 8 • replacing the exfoliating band

Advertising
background image

4

MAINTENANCE AND CLEANING

Clip the Exfoliator Head to the epilator

(fig.17)

. Set the switch to 1

(fig.18)

and

start exfoliating with a slow, gentle up
and down movement

(fig.19)

.

After peeling, we advise you to wipe
over the area with a moist flannel to
remove any dead skin

(fig.20)

and dry

the skin thoroughly afterwards.
When using the Micro-Peeling function
for the first time or if your skin is very
delicate, we recommend :

skin is wet before peeling, use cotton
wool or a flannel to do this.
Making slow and gentle rotating move-
ments when using the appliance, not to
use the appliance more than twice on
the same area.

IMPORTANT
Use the Exfoliator Head 2 days after
depilation to avoid irritating your skin.
And not to use a peeling gel or cream
at the same time.

Stop the appliance

(fig.21)

. Press the

release button on the head and remove
the epilator head

(fig.22)

. Rinse the

epilator head under cold running water
by turning it for 5 to 10 seconds

(fig.23)

.

Shake the epilator head vigorously

(fig.24)

and dry it with a towel before

fitting it to the epilator again.

6 • Cleaning the epilator head

IMPORTANT
You can also use the small
cleaning brush supplied (fig.25).

7 • Cleaning the sensitive area accessory

Clean the accessory with alcohol and
rinse it under running water

(fig.26)

.

IMPORTANT
Do not apply alcohol to the body of
the appliance to avoid its colours
changing.

8 • Replacing the exfoliating band

We recommend that you change the
exfoliating band after three sessions of
exfoliation or when it is worn out. Press
the release button to remove the
Exfoliator Head from the epilator

(fig.28)

.

Using the plastic end of the cleaning
brush unclip the band as follows :

- turn the Exfoliator Head over and hold
it in place by gripping the edges bet-
ween your thumb andforefinger;
- turn the band so that its groove comes
round to the central position;
- insert the end of the cleaning brush in
the groove

(a)

and push to eject the

band

(fig.29)

;

022656 EP5510 Row 10/02/06 10:09 Page 4

Advertising