Shure GLXD4 Wireless Receiver - Manual (Page 9)

9
Transmitters
Transmitter Status LED
① Antenna
Carries wireless signal.
② Status LED
LED color and state indicate transmitter status.
③ Power Switch
Turns the transmitter on/off.
④ TA4M Input Jack
Connects to a 4-Pin mini connector (TA4F) microphone or instrument
cable.
⑤ Micro USB Charging Port
Connect to USB battery charger.
⑥ Link Button
• Press and hold within 5 seconds of power-on to manually link with
receiver
• Press momentarily to activate Remote ID function
⑦ Battery Compartment
Holds 1 Shure rechargeable battery.
⑧ Microphone Cartridge
GLXD-2 transmitter models are available with the following cartridge
types: SM58, Beta 58, SM86, Beta 87A.
Wearing the Bodypack Transmitter
Wearing the Headworn Microphone
Correct Microphone Placement
Clip the transmitter to a belt or slide a guitar strap through the transmitter
clip as shown.
For best results, the belt should be pressed against the base of the clip.
• Position the headworn microphone 13 mm (1/2 in.) from the corner of
your mouth.
• Position lavalier and headworn microphones so that clothing, jewelry,
or other items do not bump or rub against the microphone.
• Hold the microphone within 12 inches from the sound source.
• For a warmer sound with increased bass presence, move the
microphone closer to the sound source.
• Do not cover grille with hand.
LED is green during normal operation.
LED color or flashing indicates a change in transmitter status as shown in
the following table:
Color State Status
Green Flashing (slow) transmitter attempting relink with
receiver
Flashing (fast) unlinked transmitter searching for
receiver
Flashes 3 times indicates locked transmitter when pow-
er switch is pressed
Red On battery life < 1 hour
Flashing battery life < 30 minutes
Red/Green Flashing remote ID active
Amber Flashing battery error, replace battery
1
1
2 3
2
3
4
5
6
5 6
7
7
8
off on
GLXD2
on
13 mm
(.5 in.)