Troublesh ooting guide – SoundMax SM-CDM1037 User Manual

Page 21

Advertising
background image

21

Troubleshooting guide

Below is a table describing simple measures that can help you eliminate most problems likely to emerge

when this unit is in use. If below measures do not help, turn to a service center or to the nearest dealer.

Symptom

Cause

Solution

No power

The car ignition is not on.

The fuse is blown.

If the power supply is properly connected

to the car accessory switch the ignition key

to “ACC”.

Replace the fuse.

Disc cannot be loaded.

Presence of disc inside the player.

Remove the disc in the player then put a

new upward.

Disc cannot be read.

Inserting the disc in upside down.

Compact disc is extremely dirty or

defective.

Temperature inside the car is too

high.

Insert the compact disc with the label

facing upward.

Clean the disc or try to play a new one.

Cool off until the ambient temperature

returns to normal.

No sound

Volume is in minimum.

Wiring is not properly connected.

Adjust volume to a desired level.

Check wiring connection.

The operation keys do

not work.

The built-in microcomputer is not

operating properly due to noise.

Front panel is not properly fix into

its place.

Press the power button for about 10

seconds to reset the unit

Sound skips.

The installation angle is more than

30 degrees.

The disc is extremely dirty or

defective.

Adjust the installation angle to less than 30

degrees.

Clean the compact disc/try to play a new

one.

The radio does not work,

radio station automatic

selection does not work.

The antenna cable is not

connected the signals are too

weak.

Insert the antenna cable firmly select a

station manually.

Advertising