SoundMax SM-CDM1043 - Manual (Page 15)

15
Radio operations
Band select
Press BND/ID3 button repeatedly to select your desired radio band during Radio mode: FM1, FM2, FM3, AM1
(MW1), AM2 (MW2). In each set of the bands you can store up to 6 preset stations, making total 30 preset
memory stations.
Auto/Manual tuning
Press and hold PREVIOUS/NEXT buttons to display MANU TUNE. Now you can press these buttons
repeatedly to adjust the needed frequency manually.
To adjust the needed frequency automatically, press PREVIOUS/NEXT buttons. The radio will seek to the
next down or up strong and clear frequency station. Repeat this action to seek for other desired stations.
Programming tuner stations
There are six numbered preset buttons, under which you can store and recall stations for each band. Select
the needed station, then press and hold a preset button. The station will be saved in the memory under the
corresponding number. To recall a stored station, press the corresponding preset button.
Automatic store/preset scan
Automatic store: Press and hold F/PS button. The radio will automatically store the 6 strongest available
stations to the 6 preset memories of the 3 FM or 2 MW bands (depending on which is current). To stop
auto store, press this button again.
Preset scan: Press F/PS button, the receiver will scan the saved stations in the current band.
Mono/Stereo control (in FM radio mode)
Press SEL button until the display shows STEREO (MONO). Turn VOLUME knob to switch between stereo
reception or mono reception. Improvement of reception of distant stations can be done by selecting mono
mode, which may cut down some reception noise.
Local radio station search
Press SEL button to choose LOCAL (DX). When the LOCAL function is on, the local stations (stations with
weak radio signal) can be played. When the DX function is on both local and distant stations (stations with