SoundMax SM-SA604 - Manual (Page 2)

2
Your new high-fidelity bridgeable/stereo amplifier is designed to deliver maximum
enjoyment and one year of trouble-free service.
Features
Class ''AB'' Technology MOSFET PWM Power Supply
Remote turn-on of the amplifier via car radio
Continuously Variable 12dB/Octave High Pass & 12dB/Octave Low Pass Crossover
Enhanced Bass Boost 0/12dB @50Hz
Regulator for input sensitivity
Bridgeable 4-/3-/2-/1-channel & Tri-mode
Silver Plated RCA & Power, Speaker Terminal
Soft Start & Muting
Capsulated screw terminals of loudspeaker and power supply
Overload, Thermal, Short Circuit Protection
Power & Protection indicator
Precautions: Read First!
If after reading the direction you feel uncomfortable about installing the amplifier in your car, or not
equipped or competent to do so, you should have the amplifier installed by an authorized installer.
It's your car!
Negative battery terminal must be disconnected before any electrical connections are made.
Be sure choose a location that provides substantial ventilation for the amplifier. The most preferred
locations would be in your car's trunk, under the front seats or on the back wall of a truck.
The location chosen should provide at least 2" of clearance above the amplifier for adequate
ventilation.
If the amplifier is to be mounted vertically be sure that it is in a place where adequate air will flow
along the length of its heatsink fins for cooling.
Never mount the amplifier up side down, this will cause the heat to rise back into the amplifier
causing thermal shutdown or possible permanent damage.
Never mount the amplifier in a location that is subject to direct sunlight or exposed to moisture.
Be sure to mount the amplifier to a strong, solid surface which will not give way under the stress of a
sudden stop.