Hyundai H-VC1086 - Manual (Page 5)

5
recommended to open the cap of bigger diameter for more easy empty the container from refuse, and the HEPA housing could be pulled out from the dust
container through the bigger diameter aperture only. To open the cap of less diameter press the release button situated just aside the cap (refer figures 4 and
5). To open the cap of bigger diameter rotate it just a little anti-clockwise until it clicks, then disjoin the cap and the container (refer figures 1 and 2 ).
Empty dust bin container
Disjoin the housing of HEPA-filter from big cap by turning it clockwise, and then pull out the HEPA (refer figures 3 and 6).
For cleaning the filter use brush and water, HEPA housing and the container could be just cleaned with water.
Let the HEPA-filter, the HEPA housing and the container dry up completely.
Fix the HEPA-filter into the bigger cap (the HEPA has three lugs which to be set into proper 3 slots situated at the big cap)
Pull over the HEPA housing and rotate it anti-clockwise to fix till it clicks, attach the bigger cap to the container.
Insert the container back.
HEPA-filter self-cleaning.
At the outer part of the big cap is situated the HEPA self-cleaning knob (refer the picture below). It can be used when the dust container is almost full
of refuse and you feel the suction force is fallen down. You should just turn off the power and whirl the self-cleaning knob more than two circles
clockwise or anti-clockwise, so you will find the suction power return to the prime level.
Anyway this operation doesn’t let the HEPA to be cleaned completely, so after certain time, you need disassemble the unit to wash the HEPA.
Cleaning the HEPA-filter at the wind outlet
Switch off the appliance and pull out the plug from the power supply.