Instrument cluster descriptions – FIAT Freemont User Manual

Page 245

Advertising
background image

INSTRUMENT CLUSTER
DESCRIPTIONS

1. Air Bag Warning Light

This light will turn on for four to eight sec-
onds as a bulb check when the ignition switch
is first turned to ON/RUN. If the light is
either not on during starting, stays on, or

turns on while driving, have the system inspected at an
authorized dealer as soon as possible. Refer to “Occu-
pant Restraints” in “Safety” for further information.

2. Malfunction Indicator Light (MIL)

The Malfunction Indicator Light (MIL) is part of
an onboard diagnostic system, called OBD, that
monitors engine and transmission control sys-

tems. The light will illuminate when the key is in the
ON/RUN position, before engine start. If the bulb does
not come on when turning the key from OFF to
ON/RUN, have the condition checked promptly.

Certain conditions, such as a loose or missing gas cap,
poor fuel quality, etc., may illuminate the MIL after
engine start. The vehicle should be serviced if the MIL
stays on through several of your typical driving cycles.
In most situations, the vehicle will drive normally and
will not require towing.

Prolonged driving with the MIL on could
cause damage to the engine control sys-
tem. It also could affect fuel economy

and drivability. If the MIL is flashing, severe cata-
lytic converter damage and power loss will soon
occur. Immediate service is required.

WARNING!

A malfunctioning catalytic converter, as
referenced above, can reach higher tem-

peratures than in normal operating conditions.
This can cause a fire if you drive slowly or park
over flammable substances such as dry plants,
wood, cardboard, etc.This could result in death or
serious injury to the driver, occupants or others.

3. Electronic Stability Control (ESC) Activation/
Malfunction Indicator Light (for versions/markets,
where provided)

The “ESC Activation/Malfunction Indicator
Light” in the instrument cluster will come on
when the ignition switch is turned to the
ON/RUN position. It should go out with the

engine running. If the “ESC Activation/Malfunction In-
dicator Light” comes on continuously with the engine
running, a malfunction has been detected in the ESC
system. If this light remains on after several ignition

239

KNOWING

YOUR

VEHICLE

SAFETY

STARTING

AND

DRIVING

WARNING

LIGHTS

AND

MESSAGES

IN AN

EMERGENCY

SERVICING

AND

CARE

TECHNICAL

SPECIFICATIONS

CONTENTS

Advertising