FIAT Sedici - Manual (Page 71)

70
❒ following ESP ® system intervention (for
versions/markets, where provided),
to reset the stored speed, follow these
steps.
❒ Accelerate gently, bringing the vehicle
close to the stored speed.
❒ Engage the gear selected at the time the
previous speed was stored.
❒ Press the “RES/ACC” button (2).
INCREASE IN STORED SPEED
When Cruise Control is operating, there
are two ways to increase the stored
speed:
❒ by pressing the accelerator and then
storing the new speed reached,
or
❒ by pressing the “RES/ACC” button (2).
Each time the button is pressed, this
corresponds to a constant increase in
speed, while holding the button down
increases the speed in a continuous
manner.
REDUCTION OF STORED
SPEED
When Cruise Control is operating, there
are two ways to reduce the stored speed:
❒ by disengaging the device and then stor-
ing the new speed,
or
❒ by pressing the “SET/COAST” button
(3). Each time the button is pressed, this
corresponds to a constant decrease in
speed, while holding the button down
decreases the speed in a continuous
manner.
DISENGAGING OF THE DEVICE
The device is disengaged in one of the fol-
lowing cases:
❒ pressing the “CANCEL” button (4);
❒ pressing the brake pedal;
❒ pressing the clutch (on vehicles with
manual gearbox);
❒ switching off the engine (starter switch
set to “OFF”);
❒ by disabling the system (“MAIN” but-
ton (1) set to “OFF”);
❒ when the vehicle speed is reduced by
approximately 20% compared with the
set speed;
❒ when the vehicle speed is below 36
km/h (22 mph);
❒ in the event of ESP ® system interven-
tion (where provided);
❒ in the event of system breakdown.
NOTE By pressing the accelerator, the
system is not actually disengaged, but the
required acceleration takes precedence
over maintaining the stored speed: Cruise
Control, however, remains enabled and
will return to the previous condition once
the accelerator has been released, with-
out having to press the “RES/ACC” but-
ton (2).
IMPORTANT When travelling with the
device on, never set the gearshift lever to
neutral.
IMPORTANT In the event of malfunction
or failure, disable the device (“MAIN” but-
ton (1) set to “OFF”) and see your Fiat
Dealership.