JVC KS-BTA200 - Manual (Page 8)

6
ENGLISH
Mounting the adapter unit
Wipe clean the selected surface sufficiently, and affix
the Velcro tape.
• If the Velcro tape (hard) adheres to the car mat
directly, you may install this unit without using the
Velcro tape (soft).
• The serial number is printed on the label placed on
the bottom of the unit. Do not cover up the label
with the velcro tape.
Getting Started
Warning
Avoid installing the adapter unit and the microphone
unit in the following places.
– Where they would hinder your safety driving.
– Where they would be exposed to direct sunlight
or heat directly from the heater or placed in an
extremely hot place.
– Where they would be subject to rain, water splashes
or excessive humidity.
– Where they would be subject to dust.
– Where they would be positioned on an unstable
place.
– Where they could damage the car’s fittings.
– Where radio wave interferes (EX.: trunk, etc.).
Interface adapter unit
Velcro tape (soft)
(supplied)
Velcro tape (hard)
(supplied)
Installation
KS-BTA200_book.indb 6 KS-BTA200_book.indb 6 06.12.21 5:07:37 PM 06.12.21 5:07:37 PM