SINBO SSI 2856 - Manual (Page 11)

- 10 -
TO LET THE IRON HEAT UP AGAIN
The red shot-off pilot goes out. If the temperature of the soleplate dropper below the
set ironing temperature, the temperature pilot goes on.
If the pilot light goes on after you have move the iron, wait for it to go out before you
start ironing.
If the pilot light does not go on after you move the iron, the soleplate still has right
temperature and iron is ready for use.
SELF-CLEAN FUNCTION
You can use the self-clean function to remove scale and impurities
Use the self-clean function once every two weeks. If the water in your area is very
hard, the self-clean function should be used more frequently.
a. Make sure the appliance is unplugged
b. Set the steam control knob to position "O"
c. Fill the water tank to maximum level.
d. Select the maximum ironing temperature.
e. Put the plug in the well socket.
f. Unplug the iron when the amber temperature pilot light has gone out.
g. Hold the iron over the sink, press and hold the self-clean button and gently shake
the iron and fro.
(Steam and boiling water will come out of the soleplate. Impurities and flakes if any will
be flushed out.)
h. Release the self-clean button as soon as all water in the tank has been used up.
Repeat the self-clean process if the iron still contains a lot of impurities.
CARE AND CLEANING
1. Turn the Temperature Control Dali to OFF, then disconnect the iron from the wall
outlet and it cool down completely.
2. Deposits and other residues on the sole plate can be removed with a cloth soaked
in a vinegar/water solution.
3. The casing may the wiped with a damp cloth and then polished with a dry one.
4. Never use any abrasives to clean the sole plate.
5. Keep the sole plate smooth; avoid contact with metal objects.
6. When you have fished ironing or when you are leaving iron unattended:
-turn the steam control knob (7) to position "0", and the Temperature Control
Dali to OFF -stand the iron up right, -disconnect the iron from the wall outlet.
7. Do not allow children to touch the iron or the power cord when ironing.
8. Do nor immerse the iron or the cord into water or any other liquid.
9. Do not touch hot metal parts, hot water or steam. There parts become hot and may
cause bums. Take care if you turn the iron upside downs: there parts become hot and
may cause bums. Take care if you turn the iron upside downs: there may be not hot
water in the tank.