MAXWELL MW-3010 R - Manual (Page 10)

10
ENGLISH
the desired temperature value, the (9) in-
dicator will go out, you can start ironing.
Note: While steam ironing set the tem-
perature «•••» or «МАХ».
WATER SPRAYER
• You can dampen the fabric by pressing
the spray button (4) several times.
• Make sure that there is enough water in
the water tank (10).
IRONING
• Place the iron on the base (8).
• Insert the power plug into the outlet.
• Set the temperature regulator (11) to the
required ironing temperature: “•”, “••”,
“•••” or “max” (depending on the type
of fabric), the (9) indicator will light up.
• When the sole temperature (13) reaches
the desired temperature value, the (9) in-
dicator will go out, you can start ironing.
• After you finish ironing set the (11) regu-
lator to the “min” position.
• Pull the plug out of the socket and let the
iron cool down completely.
STEAM IRONING
For steam ironing set the temperature reg-
ulator to «•••» or «МАХ».
• Place the iron on the base (8).
• Insert the power plug into the outlet.
• Make sure that there is enough water in
the water tank (10).
• Set the temperature regulator (11) to the
required ironing temperature: “•••” or
“max”, the (9) indicator will light up.
• When the sole temperature (13) reaches
the desired temperature value, the (9) in-
dicator will go out, you can start ironing.
• Turn the steam supply regulator (3) to set
the intensity of steaming, steam will start
outgoing from the openings of the sole
(13).
• After you finish ironing set the (11) regula-
tor to the “min” position and the steam
supply regulator (3) to the left position.
• Pull the plug out of the socket and let the
iron cool down completely.
ATTENTION!
If during the operation steam is not con-
stantly supplied, check whether the tem-
perature regulator (11) is set properly.
ADDITIONAL STEAM RELEASE
Additional steam release function is useful
when ironing folds and can only be used at
high ironing temperatures (when the iron
temperature regulator (11) is set to “•••”
or “max”).
• When the additional steam release but-
ton (5) is pressed, steam will be vigor-
ously released from the openings in the
iron sole.
Note: In order to avoid leakage of water
from steam openings, press the addi-
tional steam supply button (5) with 4-5
sec. interval.
STEAM CHAMBER CLEANING
To prolong lifetime of the iron we recom-
mend cleaning the steam chamber, espe-
cially in the regions with “hard” water.
• Fill the water tank (10) till the MAX mark
(12).
• Set the steam supply regulator (8) to the
steam release OFF position.
• Put the iron on the base (9).
• Insert the power plug into the outlet.
• Set the temperature regulator (11) to the
MAX. temperature: “max” the (9) indica-
tor will light up.
• When the sole temperature (13) reaches
the desired temperature value, the (9) in-
dicator will go out, you can start cleaning
of the iron chamber.
• Unplug the iron, set the temperature reg-
ulator (11) to the «MIN» position.
• Pull the plug out of the socket.
MW-3010.indd 10 MW-3010.indd 10 03.12.2009 14:50:14 03.12.2009 14:50:14