Carrier 42XQ_42XQA - Manual (Page 12)

11
NOTE
USING THE WIRELESS REMOTE CONTROL
When the air conditioner is disconnected,
the control display shows only the hour of
the day (if other icons are shown,
disconnect the control by pressing the
“ ” button).
Press the “ ” button to connect the unit.
All of the selected and saved functions light
up; the unit operates according to the
functions selected. Press the “ ” button
to disconnect the air conditioner. All of the
unit’s signals disappear and the control
display shows the current time only. If the
unit does not stop, connect the control (by
pressing the “ ” button) and repeat the
operation.
If the “ ” button is pressed immediately
after the disconnection of the unit, the unit
only starts operating again after 3 to 5
minutes due to the protection against the
frequency cycle of the compressor.
The unit only emits the BEEP acoustic
signal when the orders have been received
correctly.
The operating mode of the air conditioner
can be selected with this button.
By pressing this button repeatedly, the
available operating modes are selected
sequentially. The unit recognizes the signal
received with a confirmation BEEP and the
operating mode selected is indicated as
follows:
Connect / Disconnect
(Key B)
Select the Operating Mode
(Key A)
Indicated symbol
Setting the desired temperature
By pressing the buttons “ ” and “ ” ,
you increase or decrease the desired
ambient temperature. With each touch of
the button, the unit emits the confirmatory
BEEP acoustic signal and the selected
temperature appears on the display.
The selected temperature may be between
17
o C (63 o F) and 32 o C (90 o F) at 1-degree
intervals.
Ventilation (fan only)
Cooling with dehumidification
Dehumidification only
<
Increase
(Key C)
Decrease
(Key D)
<
<
<
• In cooling mode, if the temperature
selected is higher than the ambient
temperature, the unit will not start
operating.