M-AUDIO EQMan - Manual

i
Table of Contents
Error! No table of contents entries found. FCC Radio and
Television Interference Statement for a Class 'B' Device
This equipment generates and uses radio frequency energy and if not
installed and used properly, that is, in strict accordance with the
manufacturer's instructions, may cause interference to radio and television
reception. It has been type tested and found to comply with the limits for a
CLASS 'B' computing device in accordance with the specifications in
Subpart B of FCC Rules and Regulations (as outlined in the Code of Federal
Regulation, Title 47), which are designed to provide reasonable protection
against such interference in a residential installation.
If this equipment does cause interference to radio or television reception,
which can be determined by turning the equipment off and then on, the user
is encouraged to try to correct the interference by one or more of the
following measures: 1) reorient or relocate the receiving antenna;
2) increase the separation between the equipment and the receiver;
3) connect the equipment into a different outlet so that the equipment and
receiver are on different branch circuits; 4) ensure that the card mounting
screws, connector attachment screws and all ground wires are secured and
tight; and 5) consult the dealer or an experienced radio/TV technician for
help.
Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate this equipment.
This device complies with Part 15, of the FCC Rules. Operation is subject to
two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received including interference that
may cause undesired operation. Its FCC identification number is:
IMJEQMAN
Note: This product was FCC certified under test conditions that included
the use of shielded I/O cables and connectors between system components.
To be in compliance with FCC regulations, the user must use shielded
cables and connectors sand install them properly.
This product also complies with European CE requirements.