Candy GO DC 36 - Manual (Page 14)

Important: Always switch off and remove the plug from the electricity supply
before cleaning the condenser.
To maintain the efficiency of the dryer regularly check that the condenser is clean.
To remove the condenser
1. Remove the kickplate (see page 13).
2. Turn the two locking levers anti-clockwise and pull out the condenser.
3. Pull out the condenser unit.
4. Gently remove any dust or fluff with a cloth,
then wash the unit by holding it under a
running tap turning it so that water flows
between the plates, to remove any dust or
fluff.
5. Refit the condenser ensuring it is in the
correct way (as indicated by the arrow) and
pushed firmly into place. Lock the two levers
by turning them clockwise.
6. Refit the kickplate.
The Sensor Dry machine gives many options
for drying the laundry to suit all
circumstances.
Note: The sensor may not detect a small load
of small articles. For small loads and separate
items or pre-dried fabrics with low moisture
content, use the timed programmes. Set the
14
Condenser
Selecting the
Programme
40005127Eng.qxd 13/06/2007 12:49 Page 14