Operation, Cancelling and resetting the programme, Delay start function – Candy GO DC 78-88 User Manual
Page 16
1.
Open the door and load the drum with laundry. Ensure that garments do
not hinder closure of the door.
2.
Gently close the door pushing it slowly until you hear the door 'click' shut.
3.
Press the button to switch on the dryer. The indicator will light up and
the programme number will be indicated.
4.
Turn the Programme Selector dial to select the required drying program
(see Programme Guide).
5.
If drying synthetics, acrylics or delicate items, press the button to
reduce the heat level.
The light above the push button will light up when the machine is in low
heat setting. To deselect this status the machine must be reset.
6.
Press the Start button. The dryer will start automatically and the
indicator will be continuously lit. The time to the end of the program will
be shown on the display.
7.
The display will show the drying progress in terms of time remaining, the
indicator will remain lit.
8.
If the door is opened during the programme to check the laundry, it is
necessary to press Start to recommence drying after the door has been
closed.
9.
When the 15' indicator is lit the machine will enter the cool down phase,
the clothes will be tumbled in cool air allowing the load to cool down.
10. When the programme is complete the Display will show 0'min. and the
buzzer will sound for 10 seconds.
11. Following the completion of the cycle the drum will rotate intermittently to
minimise creasing, the buzzer will also sound. This will continue until the
machine is reset or switched OFF.
Cancelling and resetting the programme
To cancel a programme press the Start button for 5 seconds. The machine will
indicate that it has been reset by the display flashing. It is possible to change the
programme within the first 10 minutes without using the cancel and reset
function.
Delay Start Function
The function allows the user to delay the start of the drying cycle by up to
23 hours.
When the function is first selected the display will show a delay of 1 hour,
16
Operation
40004853.qxd 14/12/2006 10:39 Page 16