Trouble shooting, English – Candy AB CDC 168 - SY User Manual

Page 13

Advertising
background image

13

ENGLISH

Trouble shooting

Should your dryer operate incorrectly,
check the following points before calling
for a service engineer.
Drying time is too long/clothes are not
dry enough:
● Have you selected the correct drying

time/programme? Go to page 9.

● Were the clothes too wet? Were the

clothes thoroughly wrung or spin-
dried?

● Does the filter need cleaning? Go to

page 7.

● Does the condenser need cleaning? Go

to page 8.

● Is the dryer overloaded? Go to page 6.
● Are the inlets, outlets and base of the

dryer free from obstructions?

● Has the ‘DELICATES’ button been

selected from a previous cycle? Go to
page 10.

The dryer does not operate:
● Is there a working electricity supply to

the dryer? Check using another
appliance such as a table lamp.

● Is the plug properly connected to the

mains supply?

● Is there a power failure?
● Has the fuse blown?
● Is the door fully closed? Go to page 11.
● Is the dryer switched on, both at the

mains supply and at the machine? Go to
page 10.

● Has the drying time or the programme

been selected? Go to page 10.

● Has the machine been switched on

again after opening the door? Go to
page 7.

● Has the dryer stopped operating

because the water tray is full and needs
emptying? Go to page 8.

Filter Care Indicator on
● Does the filter need cleaning? Go to

page 7.

Empty Water Indicator on
● Does the water container need

emptying? Go to page 8.

If the supply cord on this appliance is
damaged, it must be replaced by a special
cord which is only available from GIAS
Service or an authorised Dealer.
Should there still be a problem with your
dryer after completing all the
recommended checks, please call GIAS
Service for advice. They may be able to
assist you over the telephone or arrange for
a suitable appointment for an engineer to
call under the terms of your guarantee.
However, a charge may be made if any of
the following applies to your machine:
● Is found to be in working order.
● Has not been installed in accordance

with the installation instructions.

● Has been used incorrectly.

40001717ENG.fm Page 13 Saturday, July 10, 2004 7:32 PM

Advertising