Candy AB CDC 668 - SY - Manual (Page 16)

1. Open the door and load the drum with laundry. Ensure that garments do
not hinder closure of the door.
2. Gently close the door pushing it slowly until you hear the door 'click'
shut.
3. Press the On/Off button to switch on the dryer. The indicator will light up
and the START indicator will flash.
4. Turn the Programme Selector dial to select the required drying program
(see Programme Guide).
5. If drying synthetics, acrylics or delicate items, press the Delicados
Sintéticos button to reduce the heat level.
The light above the push button will light up when the machine is in low
heat setting. To deselect this status when the drying cycle has started it is
necessary to reset the machine.
6. Press the START button. The dryer will start automatically and the START
indicator will be continuously lit.
7. The TIEMPO RESTANTE display will show the drying progress in terms of
time remaining.
8. If the door is opened during the programme to check the laundry, it is
necessary to press START to recommence drying after the door has been
closed.
9. When the 15' indicator is lit the machine will enter the cool down phase,
the clothes will be tumbled in cool air allowing the load to cool down.
10. When the programme is complete the STOP indicator will light.
Cancelling and resetting the
programme
To cancel a programme press the START button for 5 seconds. The machine will
indicate that it has been reset by the START indicator flashing. It is possible to
change the programme within the first 10 minutes without using the cancel
and reset function.
Start Delay (Inicio Diferido)
The Delay Start Function allows the user to delay the start of the drying cycle
by 6 or 9 hours.
When the function is first selected the display will show a delay of 6 hours, a
subsequent press of the button will increase the delay to 9 hours.
16
Operation
40001794.qxd 21/08/2004 10:14 Page 16