Candy CFBD 2650 A SN - Manual (Page 7)

7 IT 7 EN
Once the product has been embedded, place the rear part of
the column in contact with the wall so as to prevent access to the
compressor compartment.
For the product to operate correctly it is essential to allow adequate air
circulation so as to cool down the condenser located in the rear part
of the appliance.
For this reason, the column must be equipped with a rear chimney,
whose upper opening must not be blocked and with a front slot which
will be covered with a ventilation grill.
540 mm
50 mm
380 mm
50 mm
The appliance is equipped with coupling devices for the appliance
doors with the column panels (loader slide).
Dimensions of the gap to be left between the column and the ceiling.
50 mm
20
COUPLING OF THE PANELS OF THE
BUILT-IN COLUMN OF THE APPLIANCE
DOORS
Secure the slide in the inner part of the panel of the built-in column at the
desired height and at approx. 20 mm. From the outer wire of the door.
Open the doors of the built-in column and the fridge. Position the built-in
loader in the slide, then fi t it into the fridge door.
Mark the fi xing points for the screws and drill with a bit of a diameter
of 2.5.
Connect the appliance door to the cabinet panel keeping the
loader slots as guidelines.
PRECAUTIONS FOR THE CORRECT
OPERATION
Dimensions of the column lock-pickings.