Candy GOC58F-80 - Manual (Page 6)

6
Electrical requirements
Tumble dryers are supplied to operate at a
voltage of 230-240V, 50 Hz single phase. Check
that the supply circuit is rated to at least 13A.
This appliance is fitted with a moulded-on non-
rewireable plug which is already equipped with a
BS 1362 ASTA approved 13A fuse. Any
replacement must be the same rating and
specification. If the fuse cover is lost, do not use
the plug until it is replaced.
Electricity can be extremely dangerous.
This appliance must be earthed.
The socket outlet and the plug on the appliance
must be of the same type.
Do not use multiple adapters and/or extension
leads.
The plug should be accessible for disconnection
after the appliance has been installed.
The wires in the mains lead are coloured in
accordance with the following codes:
Blue
NEUTRAL
Brown LIVE
Green and Yellow EARTH
CE Appliance complies with European Directive
89/336/EEC, 73/23/EEC and subsequent amendments.
Adjusting the feet
Once the machine is in place the feet should be
adjusted to ensure that the machine is level.
You may be
charged for a
service call if a
problem with
your machine is
caused by
incorrect
installation.
If the mains cord
on this appliance
is damaged, it
must be replaced
by a special cord
which is ONLY
obtainable from
the GIAS spares
service. It must
be installed by a
competent
person.
Call
08443
712758
Installation
Do not plug the machine in and
switch it on at the mains until the
installation is completed.
40006040.qxd 03/07/2009 10:37 Page 6