Candy GO DC 38G-37S - Manual (Page 16)

1. Open the door and load the drum with laundry. Ensure that garments do
not hinder closure of the door.
2. Gently close the door pushing it slowly until you hear the door 'click'
shut.
3. Press the button to switch on the dryer. The indicator will light up
and the START indicator will flash.
4. Turn the Programme Selector dial to select the required drying program
(see Programme Guide).
5. If drying synthetics, acrylics or delicate items, press the button to
reduce the heat level.
The light above the push button will light up when the machine is in low
heat setting. To deselect this status when the drying cycle has started it is
necessary to reset the machine.
6. Press the Start button. The dryer will start automatically and the START
indicator will be continuously lit.
7. The display will show the drying progress in terms of time
remaining.
8. If the door is opened during the programme to check the laundry, it is
necessary to press Start to recommence drying after the door has been
closed.
9. When the 15' indicator is lit the machine will enter the cool down phase,
the clothes will be tumbled in cool air allowing the load to cool down.
10. When the programme is complete the STOP indicator will light.
11. Following the completion of the cycle the drum will rotate intermittently
to minimise creasing. This will continue until the machine is reset or
switched OFF.
Cancelling and resetting the
programme
To cancel a programme switch the machine off and on again. The machine will
indicate that it has been reset by the START indicator flashing.
Buzzer Operation
The buzzer will operate when the selector is rotated and when function
buttons are pressed.
To cancel the operation of the buzzer, follow this sequence. Press and hold on
the Acrylic/Synthetic ( ) and Start buttons and then turn the machine ON
using the ON/OFF switch ( ).
To switch the buzzer back on repeat the above sequence.
16
Operation
40005643Eng.qxd 27/08/2008 11:12 Page 16