Candy CFDE 4484 - Manual (Page 5)

DOUBLE DOOR TOTAL NO FROST
CONTROL PANEL
FREEZING
DEFROSTING
Open the top door of the fridge in order to access the control panel.
Turn on the thermostat dial to switch on the appliance and set the temperature of the freezer&fridge compartment. We recommend you set
the thermostat dial to 2 or 3. Turn the thermostat dial to "0" to turn off the appliance.
The orange light comes on when the thermostat dial is
turned to SUPER. In this case the compressor continues to
function as normal.
The green "ON" light shows that the appliance is functioning.
This light is on irrespective of the thermostat dial setting,
except for when the thermostat dial is set to 0.
Important: Some appliances will start working at least 6 minutes after the plug has been inserted in the power outlet and the temperature
has been set.
(Figure 1)
(Figure 2)
Defrosting of the fridge compartment occurs automatically in
this product.
A small amount of frost or drops of water on the back of the
fridge compartment when the fridge is working is normal.
Make sure the water outlet is always clean. Make sure foods
do not touch the back or sides of the fridge compartment.
N.B. This is the rating plate. If you need to contact our Service Department in the event of faults, remember to give them the
information on the plate.
Important: If the room temperature is very warm, the appliance may work continuously and a layer of frost will deposit
on the back of the fridge compartment. In this case, turn the thermostat dial to lower settings (1-2).
5 EN
SUPER ON
1
2
3
4
SUPER
0
The rating plate states the maximum quantity of food that can be frozen. First of all, create the space necessary to place the load to be frozen on
the bottom shelf of the freezer and set the thermostat dial to SUPER. At the same time, an orange indicator will light up on the panel. Freezing
will be completed after 24 hours. In any case, after 26 hours, from the SUPER position, the circuit board automatically deactivates the function,
turning off the orange light. After the freezing process reset the thermostat dial to the recommended settings.