Candy AB CST 10 M - Manual (Page 9)

11
• The air outlet must not be connected to chimneys
which are also connected to coal or gas heaters,
cookers, etc.
Fitting the air venting pipe
- Insert the flexible hose into the threaded end of the
adaptor. (Figure 1)
- Turn the hose anticlockwise until it is firmly in place
(Figure 2)
- Fit the adaptor into the dryer outlet required. (Figure
3)
- Fit the 2 plugs supplied into the air outlets not being
used.
ELECTRICAL INSTALLATION
Your dryer comes ready for connection to a 220V-
230V monophase supply.
You should ensure that your mains supply has a
capacity of at least 3 kW.
Plug the appliance into a 10 amp 220V-230V socket,
with an earth connection.
Check that the socket has an earth connection and
that it is properly connected.The earth connection is
essential for your safety, as it eliminates the risk of
electrical discharge.
Your dryer is equipped with an anti-interference
device to eliminate radio interference and disturbance
which could occur during operation.
NOTE : The manufacturer cannot accept liability for
any possible damage or harm to things or people
caused by improper connection.
Fig. 1
Fig. 2
Fig. 3