Boneco Air-O-Swiss Boneco D7064 - Manual (Page 19)

19
en
Emptying the water reservoir
When the water reservoir is full, the appliance automati-
cally switches itself off and a signal is sounded, consisting
of 15 tones. LED [1] lights up and signals that the water
reservoir is full. The water reservoir should be emptied as
follows:
• Using both hands, push gently against the sides
of the reservoir and carefully pull it out.
• Pour away the water and carefully replace the
reservoir. The LED goes out.
Directions:
1. Do not remove the float from the water reservoir. The
sensor that measures the water level in the reservoir
will not work correctly without float. If that happens,
the reservoir could leak water.
2. If the water reservoir becomes dirty, you can clean
it with cold or lukewarm water. Do not use cleaning
or scouring products, chemically treated cloths, petrol,
thinner or other solvents, as these can scratch or
damage the reservoir which can lead to it leaking
water.
3. When replacing the water reservoir, push it firmly using
both hands into the correct position. If the reservoir is
not replaced correctly, the sensor will continue to show
«RESERVOIR FULL» and the dehumidifier cannot be
turned on.
Permanent water drainage
To allow the dehumidifier to operate with continuous water
drainage, the following measures should be taken (see
illustration):
1. Turn off the appliance and remove the plug from
the socket.
2. Open the hole for the water drainage pipe in the
water reservoir (by removing part A).
3. Push a water hose (outer diameter 14 mm, inner
diameter 10 mm) through the hole and connect the
hose to the water draining connection (part B).
4. Place the end of the hose in the drain. Make sure
the hose is not folded and is laying straight.
When using permanent drainage, the water
reservoir must remain in place.
A
B
1
14
15 16
27175 D7064-EU-Manual_vec.indd 19 7.6.2007 17:37:51 Uhr