En 14 putting into operation, 13 filling the tank – Boneco Air-O-Swiss AOS U200 User Manual

Page 21

Advertising
background image

21

en

14

Putting into operation

• Remove the plastic cover of the adapter and insert the

country specific plug (13).

• Do not place it directly next to a radiator or on a

floor with floor heating. The moisture of the mist can

damage the floor surface (6 and 7) (see Safety In-

structions).

• The mist outlet must not be pointed directly at plants or

other objects. Keep a distance of at least 50 cm) (14).

• Soak the demineralization cartridge in a bowl of water

for at least 24 hours before using it. The granules have

to absorb water to reach maximum performance.

• On average the demineralization cartridge should be

replaced every 2 – 3 months. This interval can be

shorter or longer depending on the hardness of your

water.

• Read the instructions under «Filling the Tank» for filling

the water tank.

• Place the water tank onto the base (17).

• Connect the adapter to the unit and the electrical

socket and switch on the unit using the rotary switch

(18).

• The appliance will reach full capacity about 10 to

15 minutes after being switched on.

• Make sure that the power cord is not pinched

anywhere. Do not operate the appliance if the

cord is damaged (2).

13

Filling the tank

Always switch off the appliance before removing

the water tank. Do not reach inside the nebulizer

space while the appliance is running!

To protect

health safety and proper humidi-

fier function use only clean, contamination-

free, cold, fresh tap water in your humidifier. If

your water source is contaminated or if you are

uncertain of its safety use distilled water.

Do not operate the appliance when the water tank is empty!

When the water reaches the minimum level, the unit swit-

ches off automatically.

• Make sure that there are no foreign objects inside the

water tank.

• Remove the water tank cap from the tank (15). Fill the

tank with clean, cold tap water (16). Close the cap of

the water tank securely! Place the water tank onto the

base (17). Do not add any additives to the water!

• Connect the adapter to the unit and the electrical

socket and switch on the unit using the rotary switch

(18).

15

Advertising