Boneco Air-O-Swiss AOS E2241 - Manual (Page 10)

18 19
Open
13 14
Closed
15 16
17
en
Filling the tank
Always unplug the unit before removing the
water tank. Do not operate the humidifier when
the water tank is empty!
• Make sure that no foreign objects are in the water
tank.
• Take off the water tank cap to fill the tank with water
(13). Fill the tank with clean, cold water from the tap
(14). Close the cap of the water tank securely (15),
place the water tank on the base (16). Attention: before
turning round the tank and placing on the main body
make sure that the cover is properly closed!
• Carry the tank by holding it by the handle and support
from below with your other hand.
• Do not add any conditioners to the water (17).
• Insert the plug into the socket and switch on the
appliance using the on/off switch (18). The green light
comes on.
• Attention: never pour water into the air inlet or the air
outlet apertures!
• As soon as the tank is in the right position, water flows
from the tank into the water tray.
• Do not move or tip the appliance while it contains
water. Should you have to move it nevertheless, first
unplug and remove the water tank.
Description of the appliance
en
Unpacking
• Carefully remove the humidifier from the box.
• Remove the Ionic Silver Stick ® (Water purification)
from the red bag. Section «Water purification» provides
information on usage.
• Remove the plastic bag from the humidifier.
• Observe the information given on the rating plate
about the mains supply.
• Use the original packaging for storing the appliance if
you do not use the humidifier all year round.
Putting into operation
• Place the humidifier on the floor on a flat, dry surface
in the room.
• Ensure that there is good access to the humidifier
and that there is sufficient space for maintaining and
cleaning the appliance.
• For increased evaporation performance in large
rooms, place the humidifier near a radiator (do not
exceed max. temperature of 50 °C).
• Place the water tray in its place in the main body
and insert the evaporating mat in the water tray as
shown (10).
• Pass the cable through the slot in the lower corner of
the cable compartment (11). Any excess cable length
can be stowed away in the cable storage.
• Place the housing on the main body (12). Make sure
that the mat fits in the housing and is not squashed.
• Read the instructions under «Filling the Tank» for
putting water in the evaporator.
• Insert the plug into the socket and switch on the
appliance using the on/off switch (18).
• Make sure that the cable is not pinched anywhere
(8 – 9). Do not operate the humidifier if the cable is
damaged (2).
10
11
12
Evaporating mat
Cable storage (Fig.11)
Air outlet
Water tank
Sealing ring
Water tank cap
Control panel
Air inlet
Main body
Handle
Water base
Main body
18
Ionic Silver Stick ®