Acclaim Lighting X-Power TV - Manual (Page 6)

Specifications and improvements in the design of this product and this manual are subject to change
without any prior notice.
Notice:
Tension/capacity: AC110-120 V, 3.2A / AC220-240V,1.6A, 50/60Hz 150W
Fuse: 3.15A (T) 250V 5x20mm
Inputs: 1 input AC1
V / AC V, 50/60Hz, power entry
1 input XLR 3-polar DMX
Outputs: 1 output XLR 3-polar DMX transit
8 terminal output connectors (5-polar)
Control: 1 ON/OFF switch with indicator
Settings adjustment: by means of a Setup Tool(programmer)
Controllable colors: endless variations
Maximum connection capacity:
o o Temperature: 0 C ~ 40 C (with good air flow)
Air humidity: 0-95% (uncondensed)
Height: 75 mm
Width: 152mm
Length: 327 mm
Weight: 3.4 kg
10-120 220-240
A maximum loads of 50pcs X-CHIP PCB modules are allowed on a single
output and the maximum amount connected modules distributed over all 8
outputs must not exceed 100pcs.
Technical details:
1. Warnings
*This product is strictly designed to control X-CHIP LED PCB modules and may not be used in conjunction
with other appliances.
*Never open the housing without removing the power supply. Some parts may still be under tension.
*Only qualified personnel may open the housing.
*The X-Power TV is only suited for indoor use.
*Check X-Power TV for visible damage before use.
*Never exceed the maximum allowed amount of strips to connect and choose a connection cord of high
standards.
*Do not cover the ventilation area on the backside of the device. The cooling area may reach high
temperatures, so make sure there is enough room for ventilation. Do not put other devices on top of or
behind this device.
*If you find a defect, immediately turn off the device and contact your distributor.
*Do not insert objects into the ventilation area.
*Do not use this device under humid conditions.
*Do not use this device in magnetic surroundings and strongly polluted and/or dusty rooms.
*All security directions for installation and environment of use that are applicable to this product must
be observed. Only let qualified personnel work on electric connections and service.
2. Cleaning
*Only clean the product when the device is disconnected from the power supply.
*Use a dry and smooth cloth for cleaning.
*Do not use aggressive, chemical cleaning material.
*Do not let liquids penetrate the device.
*Never use sharp objects when cleaning.
General information:
- Page 6 -