Remington HC5015 - Manual (Page 4)

2
Comb Attachments Hair Lenghth
Each comb attachment is marked accordingly on its outside middle surface (3mm, 6mm,
9mm, 12mm, 18mm) 0.5mm length is achieved without any combs
INSTRUCTIONS FOR HAIR CUTTING
Note: For even cutting, allow the comb attachment/blade to cut its way through the
hair. Do not force it through quickly. If you are cutting for the first time, start with the
maximum comb attachment
STEP 1 – Nape of the neck – DIAGRAM 1
Use 3mm or 6mm guide comb.
Hold the clipper with the blade teeth pointing upwards. Begin starting at the centre of the
head at the base of the neck.
Slowly lift the clipper, working upwards and outwards through the hair, trimming just a
little at a time.
STEP 2 – Back of the head – DIAGRAM 2
With the 12mm guide comb attached, cut the hair at the back of the head.
STEP 3 – Side of the head – DIAGRAM 3
With the 3mm or 6mm guide comb attached, trim sideburns. Then change to the longer
9mm or 12mm guide comb and continue to cut to the top of the head.
STEP 4 – Top of the head – DIAGRAM 4
With the 9mm or 12mm guide comb attached, cut hair on top of the head against the
direction in which the hair normally grows.
For longer hair on top, use without a guide comb. Lift the hair on top of the head with a
small hand comb. Cut over the hand comb with the hair lifted or hold the hair between the
fingers to lift it and cut it to the desired length.
Always work from the back of the head.
STEP 5 – The finishing touches – DIAGRAM 5
Use the clipper without an attachment comb for close trimming around the base and sides
of the neck.
To produce a clean straight line at the sideburns, reverse the hair clipper. Place the
reversed clipper at right angles to the head, tips of the blades lightly touching the skin and
then work downwards.
CARE FOR YOUR HAIRCLIPPER
Your clipper is fitted with high quality blades. To ensure long lasting performance of your
clipper, clean the blades and unit regularly. Always keep the protective cap on the trimmer
blade.
ENGLISH
100593_REM_IFU_HC5015_21L.indd 2 100593_REM_IFU_HC5015_21L.indd 2 11.08.10 21:20 11.08.10 21:20