Remington HC5950 - Manual (Page 7)

7
ENGLISH
• To produce a clean straight line at the sideburns, reverse the hair clipper. Place the
reversed clipper at right angles to the head, tips of the blades lightly touching the skin
and then work downwards.
, Short Tapered Styles – “Flat Tops” & Short Cuts
• Starting with the longest guide comb attached (22 - 42mm), cut from the back of the
neck to the crown. Hold the guide comb flat against the head and slowly move the
clipper through the hair.
• Use the same procedure from the lower side to the upper side of the head. Then cut the
hair against the direction in which it grows and level with the sides.
• To give a “flat top” look, the hair on top of the head must be cut over the top of a flat
comb.
• Use a closer guide comb to taper the hair down to the neckline as desired.
C CARE FOR YOUR HAIRCLIPPER
Your clipper is fitted with high quality titanium blades that are permanently lubricated.
To ensure long lasting performance of your clipper, clean the blades and unit regularly.
Always keep the attachment guide comb on the trimmer blade.
E
AFTER EACH USE
• Ensure the clipper is switched off and disconnected from the mains.
• Remove attachment guide comb and cutter assembly.
• Gently brush the remaining hairs away from the comb and trimmer blade.
• Do not rinse the cutter assembly under water.
F RESET INSTRUCTIONS
• You will never have to force a system reset under normal conditions. If the trimmer
experiences abnormal behaviour, such as low or high touch sensitivity or subjected to
electrostatic discharge disturbance, or subjected to electrical fast transient/bursts from
the LV network, the system can be reset.
• Hold the power button for 8 consecutive seconds
• System will show 88.8mm, full battery, full lock and full boost level.
• Ensure no objects, hands or fingers are near the touch buttons.
• Push the power button once.
• Comb will travel down to its lowest setting, and display will show current battery level,
lock status and 1st boost level.
• Let the product sit until the screen dims.
• Product is now ready, turn it on and confirm proper function.
A CLEANING CAUTIONS
• Only the attachment guide combs and trimmer blade may be removed from the
product for cleaning.
• Cleaning should be done with a soft brush, such as the brush supplied with the product.
• The appliance is not washable.