VALERA X-MASTER - Manual (Page 3)

7
MAINS POWER SUPPLY
Connect the transformer the (fig.1- ref. 9) by inserting the plug into the appliance socket (fig.1 - ref.5).
Plug the transformer into the mains.
Warning: if the appliance does not work with mains power when the battery charge has run down
completely, switch it off, recharge the battery for about five minutes and then switch back on again,
running on mains power.
BATTERY OPERATION
Type 652.02
•The appliance has a LED charge indicator (fig. 2).
•• 4 LEDs lit = 100% charge
•• 3 LEDs lit = 75% charge
•• 2 LEDs lit = 50% charge
•• 1 LEDs lit = 25% charge
•The LED charge indicator (fig. 1 - ref. 8) blinks when the battery is below the level of 25% charge.
•Only recharge the battery when you note a clear reduction in appliance power.
•When the battery is fully discharged, the appliance automatically switches off.
Type 652.03
•Only recharge the battery when you note a clear reduction in appliance power.
•When the battery is fully discharged, the appliance automatically switches off.
RECHARGING THE BATTERY
•Before using the appliance for the first time, charge the battery for 3 hours (Type 652.02) or 3,5
hours (Type 652.03). For subsequent charges, allow the appliance to charge for at least 2,5 hours
(Type 652.02) or 3 hours (Type 652.03).
•Switch off the appliance using the switch (fig.1 - ref.3). The battery can only be charged when the
appliance is switched off.
•Connect the transformer (fig.1 - ref.9) by inserting the plug into the appliance socket (fig.1 - ref.5).
Or connect the transformer to the base (fig.1 - ref.6) by inserting the plug into the base plug (fig.1
-ref.5), then place the appliance on the base.
•Plug the transformer into the mains.
•During battery charging the red light comes on (fig. 1 - ref. 8).
•Type 652.02: while charging the battery, the 4 green LEDs indicate the charge level reached. When
3 LEDs are steady on (after approx. 90 min. recharging), the appliance is ready to operate in
cordless mode up to 70 min.
USE
COMPONENTS
1 Clipper
2 Set of blades for hair, 46 mm
3 On/off switch
4 Cutting length selector
5 Socket for transformer
6 Base
7 Battery charge indicator (Type 652.02 only)
8 LED charge control
9 Charger
10 Guide combs
11 Cleaning brush
12 Lubricating oil
13 Beard and moustache blade set
(optional; not supplied with the appliance)
14 Sculpting blade set
(optional; not supplied with the appliance
•Do not expose the appliance to temperatures below 0°C or above 40°C. Avoid exposing the
appliance to direct and prolonged sunlight.
•Do not leave the appliance on charge in wet places and do not recharge the appliance when it is
wet.
•The appliance comes equipped with a NiMH battery. To help protect the environment, the batteries
should not be included with ordinary domestic waste, but should be taken to a special collection
point instead.
•Have the battery removed by qualified technical personnel or by the treatment and recycling centre.
•Do not expose the battery to liquid, moisture or high humidity
•Keep the battery away from magnetic fields, sources of heat and naked flames.
•Danger of scratches or cuts. Do not use a comb or a set of blades if they are damaged. Replace
them immediately, as they may cause injury.
•Take care not to scratch the skin when handling the appliance with the set of blades without combs.
The appliance can operate either using mains power or in cordless mode, as it has a
rechargeable battery.
00060627 int giu2013 04/06/2013 12.30 Pagina 7