Precautions and tips, General safety, Disposal – Ariston MTM 1901 User Manual

Page 15: Respecting and conserving the environment

Advertising
background image

GB

15

Precautions and tips

! The appliance was designed and manufactured in

compliance with international safety standards. The

following warnings are provided for safety reasons and

must be read carefully.

This appliance complies with the following

Community Directives:

- 73/23/EEC of 19/02/73 (Low Voltage) and

subsequent amendments;

-89/336/EEC of 03.05.89 (Electromagnetic

Compatibility) and subsequent amendments;

- 2002/96/CE.

General safety

• The appliance was designed for domestic use inside

the home and is not intended for commercial or

industrial use.

• The appliance must be used to store and freeze food

products by adults only and according to the

instructions in this manual.

• The appliance must not be installed outdoors, even in

covered areas. It is extremely dangerous to leave the

appliance exposed to rain and storms.

• Do not touch the appliance with bare feet or with wet

or moist hands and feet.

• Do not touch the internal cooling elements:

this

could cause skin abrasions or frost/freezer burns.

• When unplugging the appliance always pull the plug

from the mains socket, do not pull on the cable.

• Before cleaning and maintenance, always switch off

the appliance and disconnect it from the electrical

supply. It is not sufficient to set the FREEZER

OPERATION Knob on OFF (appliance off) to eliminate

all electrical contact.

• In the case of a malfunction, under no circumstances

should you attempt to repair the appliance yourself.

Repairs carried out by inexperienced persons may

cause injury or further malfunctioning of the appliance.

• Do not use any sharp or pointed utensils or electrical

equipment - other than the type recommended by

the manufacturer - inside the frozen food storage

compartments.

• Do not put ice cubes taken directly from the freezer

into your mouth.

• Do not allow children to tamper with the controls or

play with the appliance. Under no circumstance

should they be allowed to sit on the bins or to hang

from the door.

• Keep packaging material out of the reach of children! It

can become a choking or suffocation hazard.

Disposal

• Observe local environmental standards when

disposing packaging material for recycling purposes.

• The European Directive 2002/96/EC on Waste

Electrical and Electronic Equipment (WEEE), requires

that old household electrical appliances must not be

disposed of in the normal unsorted municipal waste

stream. Old appliances must be collected separately

in order to optimise the recovery and recycling of the

materials they contain and reduce the impact on

human health and the environment. The crossed out

“wheeled bin” symbol on the product reminds you of

your obligation, that when you dispose of the

appliance it must be separately collected.

Consumers should contact their local authority or

retailer for information concerning the correct disposal

of their old appliance.

Respecting and conserving the

environment

• Install the appliance in a fresh and well-ventilated

room. Ensure that it is protected from direct sunlight

and do not place it near heat sources.

• Try to avoid keeping the door open for long periods or

opening the door too frequently in order to conserve

energy.

• Do not fill the appliance with too much food: cold air

must circulate freely for food to be preserved properly.

If circulation is impeded, the compressor will work

continuously.

• Do not place hot food directly into the refrigerator. The

internal temperature will increase and force the

compressor to work harder and will consume more

energy.

• Defrost the appliance if ice forms (see Maintenance).

A thick layer of ice makes cold transference to food

products more difficult and results in increased energy

consumption.

• Regularly check the door seals and wipe clean to

ensure they are free of debris and to prevent cold air

from escaping (see Maintenance).

Advertising