Acnodes FES 7035 - Manual (Page 2)

Copyright
This publi cati on c ontains inform ation that is prot ected by copyright. N o part of it m ay be reproduced i n
any form or by any m eans or used to make any transform ation/adaptation without the prior written
permission from the copyr ight holde rs. The manufacturer reserves the right to revise this publication and
m ake changes to its contents at any time, w ithout obl igation to noti fy any person or entity of such
revisions or changes.
©201 3. Al l Rights Reserved.
Trademarks
Al l tradem arks and registered trademarks of products appearing in this m anual are the properties of their
respective holders.
Notice:
1. The chan ges o r modifica tion s n ot expressly a ppro ved by th e p arty r espo nsible fo r compliance cou ld void th e user ’s auth ority
to op erate t he eq uipment .
2. Shielded int erfa ce ca bles must be used in or de r to comply wit h t he emission limits.
Static Electricity Precautions
It is quite easy to inadvertently dam age the system board, c omponents or devices e ven before i nstal ling
them i n your system unit. Static electri cal discharg e can dam age computer com ponents wi thout causing
any signs of physi cal dam age . You must take extra care in handl ing them to ensure against el ectrostatic
bui ld up.
1. To prevent electrostatic bui ld up, le ave the system board i n i ts anti-static bag unti l you are ready to install
it.
2. Wear an antistatic wrist st rap.
3. Do all preparation w ork on a stati c-free surface.
4. Hold the device only by its edges. Be careful not to touch any of the components, contac ts or
connections.
5. Avoi d touching the pins or contacting all m odul es and connectors. Hold modules or connectors by the ir
ends.
Impo rt ant:
Elect rost atic d ischa rge (ESD) can damage you r p rocessor, disk dr ive an d ot her compo nents. Perform t he up grade instru ct ion
pr ocedures describ ed at an ESD wor kstation on ly. If such a sta tion is no t availab le, yo u can provide some ESD protection by
wear in g a n ant istatic wrist st rap and attaching it to a met al part of the system chassis. If a wr ist strap is una vailab le, es tab lish
an d maintain contact with the syst em chassis th roug hout any p rocedures req uiring ESD protection .