ACR&Artex AeroFix 406 GPS PLB - Manual (Page 10)

Figure 7.
GPS Interface without holster
Figure 6.
GPS Interface with holster
4.7.3 GPS I (Interface) connection
The AeroFix™ 406 GPS P-ELT (P/N 2799.2 and 2799.4) comes standard with an Optical GPS data
interface with LED (Hard wire connection to you onboard GPS NEMA 0183 output). Connect the
serial port adapter to your external GPS connection data cable. Connect data plus and minus leads to
your NEMA 0183 output wire (consult onboard GPS manual for proper wiring instructions). The
ONLY reliable way to hook up your aviation electronics is to solder the leads together, cover the
solder connection and exposed wire with liquid electrician’s tape, and then slips a section of heat
shrink over the outside and seals it in place.
If the holster is on the P-ELT, align the two tabs on the
bottom of the interface with the holes in on the holster directly above the interface port (see figure 6).
Push down and turn to secure the interface cable to the holster. If the holster in not on the P-EPIRB
simply hold the interface head on top of the interface port with your finger (see figure 7).
SECTION 5 – P-ELT Holster and Bulk Head Mount
5.1
The AeroFix™ comes standard with a protective holster that will help protect your P-ELT from
damage. To install the holster, deploy the antenna and slide antenna through the open hole located
on the left side of the holster. Slide the holster to the base of the P-ELT so that the open antenna
hole is flush with the side of the P-ELT. Close the back of the holster around the back of the P-ELT
and clip into the front of the holster. Once secured, wrap the antenna around the base of the holster
and clip into antenna slot on the top right side of the holster (See figure 8).
Note: Use extreme caution; do not apply the holster over the antenna. In an emergency it is critical
that you deploy the antenna. If the holster is covering the antenna you will not be able to deploy
properly.
5.2 The AeroFix™ holster has been designed to accommodate your extreme adventures. You can
secure your P-ELT directly to backpack webbing straps or belts to ensure the P-ELT is close at
hand. Ensure the P-ELT is secured firmly and is protected before heading out to avoid damage or
loss. ACR recommends that you secure your P-ELT someplace that is easily accessible in case of an
emergency for rapid activation.
Y1-03-0175 Rev. E 9