Acroprint HandPunch 2000 - Manual (Page 14)

Mechanical Installation
Select an installation location based on the guidelines provided in the Planning an
Installation section beginning on page page 9.
Wall Plate Installation
Wall Preparation
For the following procedure protect the HandPunch from the dust and debris generated
during the wall plate installation process.
1. Remove the wall plate from the packing carton. Refer to Figure 3-1 for all wall plate
references in the following section.
2 UPPER SCREWS
HOLE
SURFACE
CONDUIT
ENTRY
Figure 3-1: Wall Plate
2. Measure and mark a point 48 1/2 inches (123 cm) from the surface of the finished
floor. This point will correspond to the Leveling Hole where the top-center point of the
HandPunch should be mounted.
3. For a hollow wall, drive a small nail into the wall at the mark and hang the wall plate
from the Leveling Hole located near the top of the wall plate.
4. For a solid wall, hold the wall plate against the wall, centering the Leveling Hole over
the mark in the wall.
NOTE