Acroprint BP125 "BOSS" User Manual

Battery powered clock user instructions

Advertising
background image

Battery Powered Clock User Instructions

Acroprint Model 125 Time Clocks

Acroprint Time Recorder Company, 5640 Departure Drive, Raleigh, NC 27616

PHONE 919-872-5800 IN USA 800-334-7190 FAX 919-850-0720

06-0106-000 Rev. K

Thank you for purchasing the Acroprint Battery Powered
Time Recorder.

This instruction sheet details the following Acroprint
Battery Powered Recorders:

1.

BP125-6

For use with four (4) standard “D” cell
Alkaline batteries (batteries not
included).

2.

BP125-R6

For use with four (4) Rechargeable 1.5
Volt DC Batteries. Equipped with built-
in Trickle Battery Charger. Recorder will
operate for several days without AC
power after charging. The batteries
should last 4 to 5 years. For use with
110 Volt or 220 Volt AC power (select
desired voltage when ordering).

3.

BP125-12

For use in a Motor Vehicle with 12 Volt
DC Battery or for use in extremely cold
climates with a 12 Volt DC Lead Acid
battery (battery not included).

General Instructions

Instructions for removing the case cover, setting the
recorder, changing the ribbon and general maintenance,
are detailed in the enclosed “General Service
Instructions”.

BP125-6: 6-Volt Battery Powered Time Clock

The Battery Powered Acroprint Recorder is designed to
operate on four (4) 1.5 VDC “D” cell batteries. Acroprint
recommends the use of Alkaline Batteries, which will
provide several months of reliable operation.














125 Battery Powered (6V DC)



Installing Batteries

To install the batteries:

• Remove the two (2) Butterfly Nuts at the top of

the Frame and pivot the clock mechanism
forward on the Pivot Screws (See Figure 1).

• The Battery Holder is mounted on the inside of

the back case. The top battery is installed with
the positive terminal on the left, as indicated on
the battery holder. The positive terminal on the
other three batteries will alternate as shown on
the battery holder.

• The recorder will advance one (1) minute within

sixty (60) seconds.

Note: If two batteries are improperly installed, the light
on the circuit board will glow RED (See Figure 2).

Weak Battery Warning

When the batteries become discharged the recorder will
beep. Acroprint recommends the batteries be replaced
within (5) days of hearing the beeping or the recorder
may lose time or stop altogether.






















Figure 1



Butterfly Nut

Pivot Screw

(4) 1.25v D-Size
Alkaline Batteries

Advertising