Activeforever Stamina EMR Conversion II Recumbent Bike Rower - Manual (Page 8)

ASSEMBLY INSTRUCTIONS
9
STEP 11
NOTE:
Thread the RIGHT PEDAL(41) onto the RIGHT CRANK(37) located at inside of the CRANK COVER(35) as
shown. Tighten the pedal securely. Select the RIGHT PEDAL STRAP(42) which has R marked on the
bottom side of the strap. Snap the three hole end onto the inside edge of the RIGHT PEDAL(41). Snap the
other end onto the outside edge of the RIGHT PEDAL(41) with the R mark on the bottom of the RIGHT
PEDAL STRAP(42). Select adjustment holes which allow your foot to be easily removed from the pedals.
Do the same way to attach the LEFT PEDAL(39) onto the LEFT CRANK(36) and snap the LEFT PEDAL
STRAP(40) onto the LEFT PEDAL(39).
STEP 12
Refer to the inset drawing. Plug the PULSE SENSOR WIRE(73) into the socket of PULSE COIL WIRE(74)
located on the SEAT CARRIAGE(64). Plug the PULSE COIL WIRE(74) into the socket of PULSE
CONNECTION WIRE(75) located on the bracket on the MAIN FRANE(1).
The RIGHT PEDAL(41) has R stamped on the end of the pedal shaft. The RIGHT PEDAL(41) has
right hand threads and is tightened by turning clockwise. The LEFT PEDAL(39) has L stamped on
the end of the pedal shaft. The LEFT PEDAL(39) has left hand threads and is tightened by turning
counter clockwise.