Activeforever Aeroneb Go 7030 Micropump Nebulizer User Manual

Activeforever Health and hygiene

Advertising
background image


Setup & Use Instructions

Step 1

Connect the Medication Cup (containing the OnQ Aerosol Generator) to the Nebulizer

Body. NOTE: Make sure the Aeroneb Go is unplugged before you add medication to the

mediation Cup.


Step 2

Fill the Medication Cup with the prescribed nebulizer medication. Never pour more

than 6 mL into the cup. CAUTION: To avoid damage to the nebulizer unit, do not use a

syringe with needle.


Step 3

Securely place Cap on Medication Cup.


Step 4

Attach Mouthpiece to the Nebulizer Body. If an optional Mask is used, then first attach

the Mask Connector Elbow to Nebulizer Body before attaching the Mask. NOTE: Masks

are an optional accessory.

Step 5

Insert the power cord connector into the back of the Nebulizer Unit.


Step 6

Plug the AC Powered Controller into a standard AC electrical outlet. Visually confirm

aerosol is coming out of the mouthpiece or mask


OR
Connect the power cord to the Battery Powered Controller. (Comes with Aeroneb 7070)

Turn On the nebulizer by pressing the “on/off” button on the Battery Powered Controller. You will
see a green light on the Battery Powered Controller light up. Visually confirm aerosol is coming
out of the mouthpiece or mask.

NOTE:
(1)
If you are using batteries and the green light is flashing, your batteries are low. You may finish
your treatment, and then replace the three” AA” batteries immediately.
(2) If the green light only comes on if the button is depressed, the batteries are low, replace the
three “AA” batteries.

Step 7

Place the mouthpiece between your teeth, with your lips firmly sealed around the

mouthpiece. If you use an aerosol mask, place the mask over your mouth and nose.

Breathe in and out slowly through your mouth until aerosol formation stop. Do not cover

the ventilation holes during use.


Step 8:

Unplug AC Powered Controller or turn off battery Powered Controller. Disconnect

from power source, disassemble Nebulizer Unit and rinse Nebulizer Unit Parts

after each use. Clean daily. Please read instructions or refer to your Aeroneb Go

Nebulizer Instruction Manual for more complete cleaning instructions.

Advertising