Activeforever Ossur Cold Rush Cold Therapy System - Manual (Page 8)

7
removing the power supply from wall socket.
Avoid getting water or ice on the flow control panel or power
•
adapter.
Always unplug this product immediately after each use.
•
Do not use while bathing. •
Do not place or store product where it can fall or be pulled into a •
tub or sink.
Do not place in or drop into water or other liquid.
•
Do not reach for a product that has fallen into water. Unplug •
immediately.
Never operate this product if it has a damaged electrical cord or
•
plug, if it is not working properly, if it has been dropped or
damaged, or dropped into water. Return the product to your
healthcare provider for examination and repair.
Keep cord away from heated surfaces.
•
NotE:
To create the safest operating conditions possible, Ossur has
designed the Cold Rush Cold Therapy System to operate on a 12
volt power supply, significantly reducing the chance of dangerous
electric shock. Great care should always be taken when using
electricity near water.
proDuCt DEFINItIoNS
The Cold Rush Cold Therapy System is designed for single patient •
use only.
Use of Cold Rush Cold Therapy System is designed to reduce
•
localized pain and swelling following surgical procedures or
trauma.
LISt oF pArtS (Figure 1)
Cold Rush Cold Therapy System A.
Hose B.
Couplings C.
Flow Control Knob D.
DC Connector E.
12V Power Supply F.
Cold Rush Pad (Sold Separately) G.
tECHNICAL SpECIFICAtIoN
Do not use any other power supply other than the one provided with
the unit.
*Electrical - power Supply
• Power Input: An external power supply for medical use.
• Input: 120V US, 230V EU
• Input frequency: 60Hz US, 50Hz EU
• Max output power: 12W
• Output Voltage: 12V
• Output Current: 1A
SAFEty StANDArDS
Cold Rush Cold Therapy System is tested and certified to comply with
the IEC60601-1 standard of electrical safety of medical devices and
IEC/EN60601-1-2, electromagnetic compatibility for medical electrical
devices. The company fulfills the requrements of ISO13485.
SEtup AND opErAtIoN
Ensure cold therapy unit is turned off, turn flow control knob 1.
counter clockwise to the off position. Do not plug in to wall
socket. (Figure 2)
Fill reservoir with water to the indicated fill line. (Figure 3)
2.
Add chopped or cubed ice to the reservoir up to the indicated fill 3.