Warning, Re-assembling the ankle clamps – Activeforever Teeter Hang Ups EZ-Up Inversion System User Manual
Page 4
Assembly & User Instructions LB-1007 Pg. 4
© COPYRIGHT 2010 Teeter and Inversion International, Ltd.
International Law Prohibits Any Copying 0110-4
To re-assemble the Ankle Clamps - reverse the process
• Remove the black end cap from the back of the ankle clamp housing.
• Follow Step Three through Step One, reversing the installation process to remove the CV Bar and re-assemble the rear
and front ankle clamp assemblies. (See Figure 5)
• IMPORTANT:
-
Make sure that the holes in the front ankle clamp assembly are on top (facing the same side as the
locking pin).
-
When inserting the bolt into the holes in the housing, be sure to slide the bolt through the loops at
the end of the spring and security cable. You may need to use needle nose pliers to pull the spring
loop and align it with the bolt.
-
Fasten securely with the nut. Test the installation of the front ankle clamps to ensure there is spring-loaded tension.
-
Replace the black end cap on the back of the ankle clamp housing.
• If you removed the locking pin when you installed the CV Bar, you MUST replace it securely before using the ankle clamp
assembly. Use channel locks or vise grips to ensure that the locking pin is fully tightened. You may want to wrap the base
of the locking pin with a cloth to prevent cosmetic scarring when tightening.
RE-ASSEMBLING THE ANKLE CLAMPS
For information about the Teeter Hang Ups
®
5-year warranty, or if you have any problems assembling the equipment or questions about
its use, please contact Customer Service at the appropriate location below:
USA & Canada:
Teeter
9902 162
nd
St. Ct. E., Puyallup, WA 98375
Toll Free (Phone) 800-847-0143 (Fax) 800-847-0188
Local (Phone) 253-840-5252 (Fax) 253-840-5757
International:
Inversion International, Ltd.
PO Box: AP 59245 New Providence Island, Bahamas
(Phone) +1-242-362-1001 (Fax) +1-242-362-1002
Failure to properly re-assemble the ankle clamps, including the locking pin, could cause serious injury
or death! Test the locking function of the ankle clamp assembly prior to use.
WARNING
!
Figure 5
Black End Cap
Black End Cap
Spring
Bottom of Ankle Housing