Activeforever Spa2Go Portable Spa (Blue) - Manual (Page 2)

INITIAL SPA START UP
1. When the spa is full and has circulated (pump and filter in
operation) for 30 minutes, using test strips, test water for bromine,
pH, and alkalinity. Follow test strip manufacturers directions for
use. If pH is below 7.2, add 2-1/4 teaspoons of pH Up for every
500 gallons of water directly to the spa. If pH is above 7.6, add 1
heaping tablespoon of pH down per 500 gallons of water directly
to the spa.
BROMINE FEEDER
1. To add bromine, remove bottom cap from feeder.
2.
Fill top feeder with bromine tablets. Replace bottom cap to the
feeder and adjust to desired setting. Feeder settings are on the
chart below. Secure with the lock ring.
3.
For super chlorination turn unit upside down to release air trapped
in top.
4.
Weather conditions, water temperature, and the number of bathers
can affect bromine and use. You may find it necessary to set the
feeder to a higher setting.
WARNING:
The Tropical Feeder was designed to use slow dissolving type
bromine. DO NOT MIX Tri-Chloral with calcium hypochlorite or
other forms of concentrated chlorine. Never mix bromine with any
form of chlorine. Fire or explosion may result. Thoroughly wash
feeder with fresh water when changing chemicals. Use caution when
filling feeder; never inhale fumes.
CAUTION: Keep out of reach of children!
1.
Fill bromine feeder with tablets and adjust window
opening. Start with 3 slots open, tighten lock ring.
2.
Retest spa next day and adjust feeder as necessary.
Unscrewing lower threaded portion of feeder allows more
“windows” to be open allowing more of the tablets to
dissolve, this increasing bromine level, raising this
decreases bromine level. Tighten lock ring after
adjustment.
DAILY SPA MAINTENANCE
1. Test water for pH and available bromine and alkalinity.
Add the appropriate spa care products to adjust water
according to its needs.
2. Run pump and filter at least 4 to 6 hours every day to
ensure proper circulation of the water and chemicals that
will prevent bacteria or algae growth.
WEEKLY SPA MAINTENANCE
1. For every 500 gallon of water, broadcast 3 tablespoons of
Shock treatment over the surface of the spa water. This
will remove contaminants such as ammonia, urine,
perspiration and oils.
2. Remove filters from skimmer and clean.
3. Add 1 cap full of De-foamer as needed.
Suggested
Feeder Setting Table
Spa/Hot Tub Feed Setting
Gallons Tri Chloro Bromine
200 *.00 0.75
400 0.75 2.00
600 1.25 4.00
800 1.75 5.75
1000 2.50 7.00
1200 3.50 9.00