Activeforever Wireless Doorbell Telephone Signaler - Manual (Page 2)

DB200 Signaler, larger of the 2 units:
The speaker switch allows you to turn the
Audio Alarm ON or OFF. ON is up and
OFF is Down.
The Dip Switches 1-6 should match the DB Sensor Dip
switches 1-6. The factory setting is 1 thru 3 ON and 4 thru
6 OFF. The 7
th and 8 th switches are not active switches and
it will not matter if they are set to ON or OFF, unless your
using 2 sensors one for the front and one for the back door.
If you need to change the dip switch settings to avoid
interference with your neighbors, make sure both units
settings match.
Dip Switch settings DB 200
Figure 1.1
Multi-Function-Input Jack:
Located on the left side of the DB Sensor, this input jack is for
installations as shown in diagram 2 & 5.
Troubleshooting & Help:
If you’ve followed the directions and are still having problems
please try the following suggestions:
1) Check battery in the sensor, must be an 9 volt alkaline type.
2) Check that dip switch settings 1-6 match both the sensor and
the signaler as shown in figure 1.1 above.
3) Check outlet for power.
4) Move the Signaler to an outlet closer to the sensor unit.
5) If using the Multi-Function input jack make sure that the wires
are not touching each other. See diagram number 2 & 5 for proper
installation.
6) Check Function setting switch for proper position.
Warranty:
Thank you for purchasing this high quality Sonic Alert product, we
hope you will have many years of satisfied use. All Sonic Alert
products come with a limited 5 year warranty so please retain
your receipt in safe place for possible future reference, you will
need in the event of warranty service.
on
off
1 2 3 4 5 6 7 8