Headset battery installation – Activeforever TV Listener Wireless Headphones User Manual
Page 5
LARGE HEADPHONE JACK INSTALLATION
Follow these instructions if your equipment has a large headphone jack (home
stereo systems).
1.
Connect the audio cord on the back of the transmitter (A) to the 6.3mm stereo
headphone adapter (F).
2.
Plug the other end of the adapter into the headphone jack on your audio device.
3.
Plug the AC adapter (C) into the jack marked “DC IN” on the back of the trans-
mitter and plug the adapter into an electrical outlet. For long periods of non-use,
we suggest unplugging the AC adapter.
MICROPHONE INSTALLATION
Follow these instructions if your equipment does not have any audio output jacks.
1.
Connect the audio cord on the back of the transmitter (A) to the microphone
adapter (G).
2.
Affix the microphone mounting piece directly over the speaker on your television
or audio device by exposing the adhesive strip. Insert the microphone into the
mounting piece.
3.
You will have to set your audio device to a very low volume. You can also change
the volume on the headset by adjusting the placement of the microphone.
4.
Plug the AC adapter (C) into the jack marked “DC IN” on the back of the trans-
mitter and plug the adapter into an electrical outlet. For long periods of non-use,
we suggest unplugging the AC adapter.
Headset Battery Installation
IMPORTANT: Charge the batteries for 16 hours prior to first use. You must only use
rechargeable batteries (included). Do NOT use alkaline batteries or you will
severely damage the unit.
The wireless headset (B) requires two rechargeable AAA batteries (included). To
access the battery compartment on each ear piece, take off the ear pads (refer to
Fig. 6). To remove the ear pads, gently pull them off the headset. Insert one recharge-
able AAA battery in each side matching positive (+) to positive (+) and negative (-) to
negative (-). Do NOT use alkaline batteries. To replace the ear pads, snap them back
on by lining up the prongs with the corresponding openings on the headset.
Charge the batteries for 16 hours prior to first use. Be sure the headset is turned off and
the transmitter is plugged in to an electrical outlet and turned on. Plug the charging
adapter from the back of the transmitter into the jack marked “CHG” on the right ear-
piece ( ) of the headset (refer to Fig. 7). The green charging indicator light on the
headset will illuminate. On a full charge, the battery life is approximately 15 hours.
Recharge when the volume begins to weaken. Do not charge for more than 24 con-
secutive hours as it will shorten the life of the batteries.
For long periods of non-use we suggest removing the batteries.
The batteries need to be replaced when they last much less than the expected time
(approximately 15 hours) after proper charging. Be sure to replace ONLY with
rechargeable AAA batteries. Do NOT mix alkaline and rechargeable batteries.
Fig. 4
{
8
}
{
9
}
Fig. 5
Fig. 6
Ear Pad
AAA Battery