Activeforever Medlight 630 Pro Near Infrared Light Therapy Device - Manual (Page 3)

5 4
5


Fig 4
Operating Instructions
(Refer to page 3(b) for illustrations)
1. Plug the power supply into the Medlight 630PRO power supply
connection, and then into a wall outlet.
2. To operate, press the START button. A
Red light will be emitted from the light
source.
If you desire to stop treatment before the
4-minute cycle is complete press the
STOP button at any time.
3. Hold the Medlight 630PRO over the area
to be treated.
4. The Medlight 630PRO has a built in
spacer lip that will help you maintain the optimal distance from the
treatment area. If using the Medlight 630PRO on intact skin, you may
place the device directly on your skin.
If using the Medlight 630PRO over broken skin, hold the device slightly
above the skin so that it does not come in contact with the broken skin.
When using the device correctly, you should feel a gentle warming of
your skin.
5. The Medlight 630PRO treatment cycle is 4-minutes. Completion of the
treatment cycle is indicated by an audible alarm.
6. To achieve the desired pain relief, two additional 4-minute treatments
are recommended.
7. After treatment is complete, unplug the POWER SUPPLY CORD from
the wall outlet.
Wait Light
The Medlight 630PRO has an internal automatic temperature sensor that will
turn the device off and illuminate the Wait Light to prevent the device from
overheating. When the device has cooled to an acceptable temperature the
WAIT Light will turn off allowing the device to resume treatment. (Please
refer to “Cautions“ in Instructions for Use to help prevent overheating of
device.)


         Pg5
4
Treatment Recommendations
Medical Devices, Inc. recommends the use of three, 4-minute treatment
cycles per session. During the first 4-minute treatment cycle your skin
temperature will rise to a therapeutic level. Continue two additional treatment
cycles to achieve optimal therapeutic benefit.
Usage Tips
For minor muscle pain and/or spasm:
x Identify the location of pain and apply the device directly to area.
For joint pain and arthritis:
x Apply the device to the joint line
area where the two bones meet
(Fig. 1).
For hard-to-reach areas:
x
A Flexible Velcro Holding Strap
is included with the Medlight
630PRO to provide hands free
operation during treatment.
Insert the device into the loop of
the strap being careful not to
cover fan vents (Fig 2 and 3).
Hold the LED light source over the treatment area and fasten the Velcro holding
strap to comfortably and securely hold the device in place.
In general, Medical Devices, Inc. recommends two to three sessions
spaced throughout the day. However, treatment may be repeated as
often as needed.
Fig. 2 Fig. 3

Fig. 1 




































         Pg4