Activeforever Pride Lift Chair Classic Collection 2 Position User Manual
Page 10
10 Lift Chair Series
Your lift chair may require some assembly before initial use. It may also require disassembly to make
servicing the chair more convenient. If your lift chair is a Knock-Down (KD) model, follow the instructions
in “Lift Chair Setup.”
LIFT CHAIR SETUP
KD models will arrive in the knock-down position.
NOTE: If your lift chair is model LC125, refer to the assembly instructions provided with the chair.
For model C20, the KD sleeves are located on the inside as shown in figure 4.1.
I V . A S S E M B L Y / D I S A S S E M B L Y
MODEL C20 ONLY
Figure 4.1 Lift Chair Assembly
1. Check that the locking clip on the back of the chair is in the vertical position. Reposition if necessary.
2. Drape the hand control and cable over the chair base, then slide the back onto the base. (KD clips may
be located on either side of the lift chair.)
NOTE: Depending on chair width, you may need to slide on one side of the back at a time. If this
is the case, level the chair-back before pressing down to lock into position.
3. Push firmly on the top of the back to lock into position. You must hear a click from each side of the chair
to ensure the back is locked in properly.
NOTE: Pull up on the chair-back to ensure that it is locked in place.