Activeforever Spa2Go Portable Spa (Blue) - Manual (Page 4)

3. Open bleeder valve on top of filter bucket. Keep
a towel around this area to catch any water that
may drain out.
Make sure rubber Gasket is seated in place around
perimeter of filter housing top groove. Replace lid
and lid retainer and tighten. Bleed air valve again.
5. Remove filter. Look down in the center hole
on the bottom of the filter tank and you will see
the paddle wheel impeller from the pump. This
is a magnetic drive circulating pump and it does
not take much of a debris clog to keep it from
spinning. Take a long, thin pencil and place in
the hole and try to turn it a few times. Remove
pencil and check to see if it spins freely on its
own. It should now pump water.
www.Activeforever.com