Activeforever HealthCraft PT Rail for Bathroom Safety User Manual
P.t. rail, Caution, Instructions
5.5”/
140mm
8”/203mm
9”/229mm
3/8”/
9.5mm
1-1/2”/
38mm
4.5”/
115mm
Copyright 2003, Specifications subject to change without notice.
INSTALLATION
INSTRUCTIONS
Models:
Thank you for investing in your independence with
HealthCraft Products. Be certain to read &
understand these instructions prior to using your new
. It is your responsibility to see that your P.T.
Rail
is properly assembled, installed, operated, and
cared for. Failure to follow these instructions could
result in injury.
The P.T. Rail
should only be installed in areas where
the mounting surface is structurally sound. If you are
not equipped to undertake the outlined work we
recommend that you have your P.T. Rail
installed by
a qualified contractor. The P.T. Rail, ( or P.T. Rail
Mast) must be secured to wall (or floor) with fasteners
appropriate to the structural material. Fasteners must
be rated for certain retention force each for maximum
weight capacity (see within for recommendations).
Mounting fasteners should be inspected monthly and
tightened if necessary.
is capable of
supporting a maximum suggested user weight of
350lbs/160kg. NOTE - Due to variances in needs,
materials and local construction methods, the
information contained within concerning mounting
location, fasteners and wall fabrication is provided as
suggestion only. Consult the appropriate local
professionals for best advice.
P.T. Rail
P.T. Rail
TM
TM
TM
TM
TM
PT-WR32L, PT-WR32R,
PT-WR28L, PT-WR28R
PT-FIX32L, PT-FIX32R,
PT-FIX28L, PT-FIX28R
CAUTION
RISK OF INJURY!
!
We strongly recommend that you give some thought as to the
optimal location of your PT-Rails
before installation. The
following suggestions are offered for your consideration,
however, it is recommended to consider advice from the
appropriate healthcare professional for locating of any
support rail. The PT Rails may be installed on only one side
or, more typically, both sides of a toilet. The PT Rail(s)
typically provide(s) most optimal support with a height to top
rail (H) of between 32-34” (81-86 cm), or more in some
cases.
In the case of two PT Rails being installed, one on each side
of the toilet, a suggested width between top rails (W) would
be in the range of 28 - 32” (71-81 cm). Always ensure that
the proposed location of your PT Rail will not obstruct access
to other parts of the bathroom. For folding models, ensure
that the space above the rail is clear to permit folding.
TM
Installation Notes
Installation Notes
Hinged Model,
Right Side
(PT-WRxxR)
Hinged Model,
shown on
optional
Floor Mast
Fixed Model,
Right Side
PT-FIXxxR
Left Side
Model
W= 28-32” (71-81 cm)
W/2
H= 32 - 34”
( 81-86 cm)
Right Side
Model
Fixed Model,
Left Side
PT-FIXxxL
28”,
32”/
710,
810
mm