Activeforever Hoyer Hydraulic Patient Lift HML400 - Manual (Page 3)

SPECIFICATIONS
M o d e l s / S p e c i f i c a t i o n s
IM-459001
4
IM-459001
A s s e m b l y 5
ASSEMBLY
The following tools are required for assembly:
HML400: 3/4" & 1/2" wrench, 3/16" hex wrench, 1/8"
hex wrench, and a thin layer of grease should
be applied to all bolts.
C-HLA & C-HLA-2: two 9/16" wrenches, 1/8" hex
wrench, and a thin layer of grease
should be applied to all bolts.
1. Carefully unpack Hoyer Lifter. Check for swivel
bar/6-point cradle and adjusting lever handle.
2a.C-HLA and C-HLA-2– Insert mast in base sleeve
(Fig. 1). Be sure notch on end of mast fits over
bolt in bottom of mast sleeve. Mast must lock
into position in base sleeve, making it impossi-
ble to rotate. Check carefully to be certain mast
cannot rotate.
2b.HML400– Insert mast in base and tighten bolt.
3. Make certain boom points in same direction as
base legs. Thread mast safety lock and stud into
threaded hole in mast sleeve. Tighten firmly,
locking mast into base (Fig. 2). Keep mast and
base locked at all times except when removing
mast from base for storage.
HML400 only– All sholder bolts must engage
through bracket on both sides. If bolt is not
fully engaged, misalignment and premature
failure may result. Worn parts could fail,
resulting in injury to resident/caregiver.
4. a. C-HLA and C-HLA-2 only– Insert boom end into
hole in yoke hinge at the top of mast. Fasten
bolt and nut (Fig. 3). Be certain hex of bolt
head fits into formed hex on side of hinge and
that plastic washer is under lock nut.
b. HML400– Attach boom to top of mast with
hardware.
5. Attach hydraulic pump to boom (Fig. 4).
Figure 1
Figure 2
Figure 3
Figure 4
C-HLA C-HLA-2HML400
Base Adj. U Adj. U Adj. U
Max. Weight Capacity 400 lbs. 400 lbs. 400 lbs.
Lift-range of Boom 29"-80" 29"-80" 28.25"-75"
Width of Base 23"-39" 23"-38" 24"-40"
Length of Base 41" 41" 43"
Base Clearance 5.5" 5.5" 5.25"
Finish Chrome Chrome Tan
C-HLA HML 400 C-HLA-2
MODELS